NCF Corporation
About UsHomeContactInstallationProductsWarranty
T-K1 Flash
T-K1 Application
T-K1 Efficiency
T-K1 Optional Parts
T-K1 Service
T-K1 Specifications
T-K1 Warranty
T-K1 FAQ's
Flash T-K2
T-K2 Efficiency
T-K2 Specifications
T-K2 Warranty
MOBIUS T-M1
T-M1 Application
T-M1 Efficiency
T-M1 Optional Parts
T-M1 Specifications
T-M1 Warranty
T-M1 FAQ's
  
Page 4Previous

Symptom: Not working with no-error sign (off) or no-error signal (A: off, B: off)

CHECK ELECTRIC RESOURCE This error is mostly related to out side
electric supply such as no-power, short-circuited, fuse blow up,
and low/high voltage. Use your electric tester to check that right
electric resource is provided properly.

  1. Open Front Cover (4) with two screws out.
  2. Push the TEST switch (lower green) on the GFI (58)
    with your finger.
  3. Red light between green buttons will be on.
    If light not on, check:
    • Fuse (56) [4.1.2]
    • Outer Electric supply (Min. 108V, Max. 132V AC)
    • Each wire connection
    • Junction box connection (61)
    • Transformer (59) [4.1.3]
    • GFI (58) [4.1.5].
  4. Push RESET switch (lower green) to turn light off on the GFI
    (58) with your finger.
  5. Red light between green buttons will be off.
  6. Push RESET switch (upper green) on the GFI (58) with your finger.
  7. Check "B" lights on the Circuit Plate (51) again.
    If "B" is not light on, disconnect & reconnect power supply
    connector (#5 white-black) on the Circuit Plate (51).
    Check two fuses on the Circuit Plate (51) [4.1.4].
 
Circuit Plate (51)
Page 4 Previous
 

Home || About Us || Contact || Installation || Product || Warranty || FAQ's